My Shower has low water pressure, what is a pressure regulator and where would it be located?
Answer:
A pressure regulator can only reduce the pressure, not increase it. While it is unlikely, it is possible you could have a regulator that is set too low, it you do have one it will probably be near where the water service enters the building.
If you have a new shower head, you may be confusing low volume for low pressure, the problem might be that a low flow shower head has been installed, which are required in some areas. You might try a different shower head, some may give a different feel for the same volume. Or if if you are in an area that does not require low flow heads , but one was been installed anyway then replacing it might help, but it could be that you just have low pressure for the whole house or (as mentioned before) clogged pipes.
if there is one, it's with your meter.
but i doubt you'll find one.
the water company only needs one for all the water in the area.
also, you know they can only reduce pressure, not increase it.
if you have one, you could reduce the pressure less.
but it would be for your whole house.
you might consider cleaning out your shower head.
or removing the flow restrictor.
or getting a head that allows more water.
Clean your shower head, that's usually the cause. Or just get a new one.
As recommended, clean the shower head since chemicals in the water tend to build up over time to cause deposits that reduce water flow. The other idea not yet expressed is to take the shower head off and look for a reducer disk. Some good Samaritan for water use reduction may have put it in there to save on water use. If that is the cause, take it out, and full line pressure should be restored.
Take the shower head off ...turn on the cold water.if it blows the back off the tub its a volume problem not pressure.clean the old head ( with CLR)or better yet get a new one at a home repair store.if there is no volume through the valve then call a plumber or try and repair/replace the valve seats. Most communities require there to be 66lbs at the main you can buy a pressure indicator that will screw on the hose bibb outside. If you have a volume difference between the cold and hot you may have internal corrosion in the piping from the water heater which only a plumber can fix properly and ask him to install cathodic protectors on the cold/hot water lines...good luck form the E!!
Check with the water utility what the local water pressure is. If you have a well on your own you already should know what the pressure is. If the shower is upstairs you might encounter a little loss of pressure. If all other pressure in the house is equally good, check your shower head for clogging. If it is not clogged, install a reducer to get a little more pressur but less water. If all else fails, get a pressure tank and a pump and hook your shower up to it. Pressure regulators only reduce pressure. So, it would do you no good unless you have one already installed and it is set too low. This is not a standard setup and rarely used when public water pressure exceeds 80 psi.
Well, you don't want a pressure regulator,
since only the water company really uses them.
But a water nozzle will increase the spray
velocity, which is probably what you want.
The answers post by the user, for information only, FunQA.com does not guarantee the right.
More Questions and Answers: